RING AND PINION INSTALLATION INSTRUCTIONS
RING AND PINION INSTALLATION INSTRUCTIONS Congratulation s on your purchase of a new G/2 Ring and,24 oz ball pee n hammer 48 oz sledge hammer 48 oz plastic dead blow hammer,burrs or irregularities that might prevent a flush mounting of the ring gear. Ring a nd pinion tooth depth and backlash variations can result from a ring gearGirth Gears - More than Just Metal and Teeth,mills and ball mills for use in the mining and cement industries. By current stan-dards, girth gears can be as large as 14 meters (46 feet) in diameter, 1.1 meters (44 inches) face width, and 50 module (.5 DP) tooth size, and weighing upwards of 120 tons. Flange mounted gears rely, in large part, on the millinstallation of grinding mill girth gear and pinion,Ball Mill Girth Gear and Pinion Alignment CR4 Discussion. 28/08/2011· Re Ball Mill Girth Gear and Pinion Alignment 08/27/2011 2 07 AM pinion alighnment is done by coating the pinion with a lead based grease. after rotating the drum the grease marks will show the contact area. the pinion should contact the girth "ring" near the center of the gears.